Technical documents
Downloads
Catalogs, datasheets and company documents. Only released documents are listed.
| Document | Type | Division | Language | Rev | |
|---|---|---|---|---|---|
| Datasheet — TS-PT Perforated Cable Tray The workhorse of every electrical installation: a ventilated base, return-flanged sides and a 3 m length supplied with … |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-ST Solid-Bottom Tray / Cable Trunking A closed base with a matching cover: full mechanical protection and clean separation of fire-alarm, data and instrument… |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-LD Cable Ladder C-section side rails with welded C-rungs at 300 mm: the choice for main feeders, substations and riser shafts. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-HB Horizontal Bends 90° / 45° Formed bends with 100 mm straight ends, for changing direction in the horizontal plane without cutting tray on site. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-HT / TS-HX Horizontal Tees & Crosses Equal three-way and four-way junctions with radiused inner corners that guide cables around the turn. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-RD Reducers (Straight / Left / Right) Width transitions along a run, centred or offset to keep one wall straight against a wall or beam. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-VR Vertical Bends — Inside / Outside Inside (raiser) and outside (faller) bends at 90° and 45° for changes of level at beams, ducts and risers. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-CV Tray Covers Flanged covers with stiffening ribs for indoor runs, and peaked covers that shed rain and debris outdoors. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-SP Splice Plates Side splice plates for straight joints, with hinged and adjustable versions for odd angles. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-FS Fastener Sets Round-head M6 bolts with serrated flange nuts for trays; M8 and M10 for ladders and supports. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-CH Channel Strut 41 × 41 / 41 × 21 Slotted lipped channel that forms hangers, brackets and frames for every tray in the range. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-CA Cantilever Arms Wall- or post-mounted arms from 150 to 600 mm that carry tray from one side and leave the other open for laying cables. |
Datasheets | Cable Trays | EN / AR | A0 | |
| Datasheet — TS-TH Trapeze Hangers Channel strut on twin threaded rods from the slab — the standard ceiling support for every tray and ladder. |
Datasheets | Cable Trays | EN / AR | A0 |
Looking for something else?
Need a document that is not listed — test reports, approvals or drawings for a specific project? Ask our technical team.
Request technical submittal