TRUSTEEL Cable Systems
Perforated trays, ladders, trunking, fittings, covers and supports — one coded system from TRUSTEEL.
Cable Management Systems
Every tray, fitting and support in the range shares the same widths, heights, hole pattern and finish, so a run fits together on site without cutting or drilling.
Perforated, solid-bottom and wire-mesh trays for power, control and data cables.
TS-PT
The workhorse of every electrical installation: a ventilated base, return-flanged sides and a 3 m length supplied with its own splice set.
TS-ST
A closed base with a matching cover: full mechanical protection and clean separation of fire-alarm, data and instrumentation circuits.
Coming soon
TS-WM
Welded 4.5 mm wire basket for data centres and light cabling. Coming once the wire-welding line is commissioned.
Ladder systems for heavy power cables, long spans and riser shafts.
TS-LD
C-section side rails with welded C-rungs at 300 mm: the choice for main feeders, substations and riser shafts.
Bends, tees, crosses, reducers and risers matched to every tray size.
TS-HB
Formed bends with 100 mm straight ends, for changing direction in the horizontal plane without cutting tray on site.
TS-HT / TS-HX
Equal three-way and four-way junctions with radiused inner corners that guide cables around the turn.
TS-RD
Width transitions along a run, centred or offset to keep one wall straight against a wall or beam.
TS-VR
Inside (raiser) and outside (faller) bends at 90° and 45° for changes of level at beams, ducts and risers.
Flanged and peaked covers that protect cables from dust, debris and sun.
TS-CV
Flanged covers with stiffening ribs for indoor runs, and peaked covers that shed rain and debris outdoors.
Splice plates and fastener sets that keep every joint continuous and bonded.
TS-SP
Side splice plates for straight joints, with hinged and adjustable versions for odd angles.
TS-FS
Round-head M6 bolts with serrated flange nuts for trays; M8 and M10 for ladders and supports.
Channel strut, cantilever arms and trapeze hangers for ceiling, wall and floor fixing.
TS-CH
Slotted lipped channel that forms hangers, brackets and frames for every tray in the range.
TS-CA
Wall- or post-mounted arms from 150 to 600 mm that carry tray from one side and leave the other open for laying cables.
TS-TH
Channel strut on twin threaded rods from the slab — the standard ceiling support for every tray and ladder.
System
Drag to orbit
Product codes
Example: perforated tray, 300 mm wide, 100 mm high, 1.5 mm thick, hot-dip galvanised. Fittings add their type and angle, e.g. TS-HB90-300-100-HDG.
Finishes
| Code | Finish | Specification |
|---|---|---|
| HDG | Hot-dip galvanised after fabrication | BS EN ISO 1461 — mean zinc ≥ 55 µm on steel 1.5–3 mm (≥ 45 µm below 1.5 mm) |
| PG | Pre-galvanised (Sendzimir) steel | EN 10346 DX51D+Z275 — 275 g/m² total, about 20 µm per side |
| PC | Polyester powder coat, RAL 7035 (any RAL on request) | 60–80 µm over pre-treated pre-galvanised or HDG steel |
| SS | Stainless steel 316L | EN 10088-2 grade 1.4404 — marine, food and chemical areas |
Share the cable tray schedule, drawings or BOQ and our sales engineers will reply with a priced offer or a technical submittal within one working day.
