Joining & Fixings · TS-SP
Splice Plates
Side splice plates for straight joints, with hinged and adjustable versions for odd angles.
Drag to orbit · scroll to zoom
Real-time 3D · illustrative
Overview
One splice plate is fitted on each side of every joint with eight M6 bolts. Correctly fitted splices keep the run mechanically continuous and electrically bonded, so the tray itself can serve as a protective conductor where the design allows.
Key features
- Straight, hinged horizontal and hinged vertical
- Supplied with each tray length
Specifications
Technical data TS-SP
| Product family | TS-SP — Splice Plates |
|---|---|
| Side heights H | 50, 100 mm |
| Thickness t | 1.5, 2.0 mm |
| Length | 200 mm |
| Material | Same steel as tray |
| Perforation | 8 × Ø7 mm |
| Code format | TS-SP[S|H|V]-[H]-[finish] |
| Code example | TS-SPS-100-HDG |
Standards
References
- IEC 61537 (test reference)
Load data
Safe working loads and support spans will be published after type testing to IEC 61537. Until then, support spacing follows the project specification; our engineers can advise on typical spans for your cable load.
Finishes
Available finishes
System
Compatible accessories
Installation
Installation notes
- Set out and fix supportsTrapeze hangers or cantilever arms on the route line; add a support within 600 mm of each fitting.
- Lay straight sectionsKeep splice joints near supports, away from mid-span.
- Join with splice platesOne plate each side, M6 round-head bolts with heads inside the tray; tighten flange nuts.
- Lay cables and fit coversTie cables to the base slots; clip covers every metre where specified.
- Earth bondingBond the run to earth where the project specification requires it.
We prepare the technical submittal for TS-SP: datasheet, dimensioned drawings, material certificates and samples, ready for consultant review.
Request technical submittal