Joining & Fixings · TS-FS
Fastener Sets
Round-head M6 bolts with serrated flange nuts for trays; M8 and M10 for ladders and supports.
Drag to orbit · scroll to zoom
Real-time 3D · illustrative
Overview
Round heads sit inside the tray so cables slide over them without damage. Serrated flange nuts lock without washers and bite through the coating for earth continuity.
Key features
- Packed per tray length
- Finish matched to tray
Specifications
Technical data TS-FS
| Product family | TS-FS — Fastener Sets |
|---|---|
| Thickness t | M6 × 12, M8 × 16, M10 × 20 |
| Material | Steel grade 4.6 / 8.8; A4 stainless |
| Code format | TS-FS-[M]-[finish] |
| Code example | TS-FS-M6-HDG |
Standards
References
- ISO 7380 / DIN 603 (bolt forms)
- ISO 4161 (flange nuts)
Load data
Safe working loads and support spans will be published after type testing to IEC 61537. Until then, support spacing follows the project specification; our engineers can advise on typical spans for your cable load.
Finishes
Available finishes
EGElectro-galvanisedISO 2081 — zinc 8–12 µm, dry indoor areas
HDGHot-dip galvanised after fabricationBS EN ISO 1461 — mean zinc ≥ 55 µm on steel 1.5–3 mm (≥ 45 µm below 1.5 mm)
SSStainless steel 316LEN 10088-2 grade 1.4404 — marine, food and chemical areas
Installation
Installation notes
- Set out and fix supportsTrapeze hangers or cantilever arms on the route line; add a support within 600 mm of each fitting.
- Lay straight sectionsKeep splice joints near supports, away from mid-span.
- Join with splice platesOne plate each side, M6 round-head bolts with heads inside the tray; tighten flange nuts.
- Lay cables and fit coversTie cables to the base slots; clip covers every metre where specified.
- Earth bondingBond the run to earth where the project specification requires it.
Need a submittal?
We prepare the technical submittal for TS-FS: datasheet, dimensioned drawings, material certificates and samples, ready for consultant review.
Request technical submittal